Home › Damage › Rotten wood treatment: what works and what to leave alone

Rotten wood treatment: fix the damp first, then decide what to repair

Soft, crumbly timber has a cause. Fix the cause before you fix the wood.

Treating rot starts with the water, not the wood

Rotten wood is timber that fungi have been digesting because it stayed wet. Wood sitting below roughly 20 per cent moisture does not rot. So the cure for rot is always the same: find where the water comes from and stop it. A coat of hardener or paint over damp timber just seals the problem in.

Most rot you will meet in a house comes from a short list of sources. A leaking downpipe, a blocked gutter, a garden bed built up against the wall, a roof flashing that has lifted, or a subfloor with no airflow. Until that source is dealt with, any repair will fail again.

Decide how bad it is before you choose a repair

The right treatment depends on how much sound timber is left and what the piece is holding up. A fence rail and a bearer are very different jobs.

What you findUsual approachWho should do it
Surface softening, a screwdriver sinks a few millimetresDry it out, cut back to sound wood, patch and sealA competent home owner for non-structural timber
Rot through a small section of a window frame or trimCut out and splice in new timber, or fill with a rated epoxy repairHome owner or carpenter
Deep rot in decking, stairs or a balustradeReplace the memberCarpenter, because these are safety items
Rot in a bearer, joist, stud or roof timberReplace or sister the member after a structural checkBuilder or structural engineer

If you are unsure whether a timber is structural, treat it as if it is. That is the safe default.

Dry it, cut it back, then repair

For minor rot in non-structural timber, the sequence matters more than the product.

  1. Fix the water source first and let the timber dry, which can take weeks in a damp subfloor.
  2. Probe the area with a screwdriver and mark where the wood stops being firm.
  3. Cut or chisel out everything soft, back to hard, dry timber.
  4. Replace the missing section with new timber, or fill the gap with a two-part epoxy wood filler made for the job.
  5. Prime every cut face and the end grain, then paint or seal to the manufacturer's directions.

Wood hardeners and fungicide preservatives have a place on small, shallow patches. Read the label and follow it closely. They are not a substitute for replacing a member that has lost its strength.

Why rotten timber can also mean termites

Damp, softened wood is exactly what termites like. Some termite groups feed on moist, decaying timber, and the rot can mask the damage they do. Termites also leave the surface of the timber thin and papery while they hollow the inside, which can look a lot like advanced decay.

So the rule is simple. Do not assume rot is only rot. Tap the timber and look at how it fails. Rot tends to break into cubes and crumble. Termite damage tends to leave galleries running along the grain, sometimes with soil or mud packed in. You cannot reliably tell them apart by eye, and a house can have both at once.

If you see mud, galleries or live insects, stop

If you cut back to sound wood and find tunnels, soil packing, or live insects, stop work straight away. Do not keep digging, do not spray, and do not pour any product into the cavity. Disturbing the colony makes it retreat and re-enter the building out of sight, and the damage carries on where nobody can see it.

A shop-bought spray also interferes with the transfer effect that professional non-repellent treatments and baits depend on, and it destroys the evidence an inspector reads. Cover the area, leave it as it is and photograph it.

Who treats what

Rot repair is carpentry. A termite problem is a different job. In Australia, termiticides are registered by the APVMA and applied by a licensed pest management technician, so any treatment of live termites is theirs to do, not yours.

If the rot sits near the ground, in a subfloor or beside a slab, ask for a timber pest inspection to the relevant Australian Standard before you repair anything. It costs you a visit and can save you rebuilding a wall twice. For why damp subfloors matter, read moisture and the subfloor. To compare the two kinds of decay, see wet rot and fungal decay. If the timber was damaged by insects instead, fixing termite damage covers the repair side.

Rot is cheap to stop early and expensive to ignore. Find the wet source this week.

Frequently asked questions

What is the best treatment for rotten wood?

Remove the water source, let the timber dry, then cut out the soft wood and replace or fill it. Products only help on small, shallow patches.

Can rotten wood be saved?

Light surface rot in non-structural timber often can. Where the wood has lost its strength, or holds up part of the building, replace it.

How do I know if it is rot or termites?

You cannot reliably tell by eye. Rot crumbles into cubes, while termite damage tends to run in galleries along the grain. If you see mud or insects, stop and call a licensed inspector.

Sources

What this page explains is based on these official sources. If you check one and it does not match what you read here, send it to us and the article gets corrected.

Keep reading