Home › Damage › Fixing termite damage: what happens first

Fixing termite damage: the steps that come before any carpentry

Replacing damaged timber feels like progress. Done first, it is wasted effort.

Do not start with the hammer

The urge to fix termite damage straight away is natural. The hole is visible and the timber is soft. But if the colony is still active, new timber is just fresh food in the same place.

So the first job is not repair. It is getting a licensed technician to find and manage the activity.

The order of work

  1. Have the activity assessed and managed by a licensed pest management technician. This is not a job for a can of spray, which can scatter the colony.
  2. Work out the extent. That usually means opening linings or lifting floor sections that the first inspection could not reach.
  3. Fix what let them in. Leaks, bridged barriers, timber in soil and poor subfloor airflow all come before the new timber goes in.
  4. Repair. Only now do you replace or reinforce what was lost.

Sort the damage into two piles

Damage to skirting boards, architraves, door jambs and cabinetry is non-structural. It looks bad, but it is not holding the building up. A carpenter can replace it in the usual way.

Damage to bearers, joists, studs, plates, lintels or rafters is structural. That is a different question entirely. The issue is how much sound timber is left and whether it still carries its load. For a badly damaged member, an engineer should assess it before anyone cuts or replaces anything. The split between the two is explained in reading soft timber.

Why the damage is usually bigger than it looks

Termites eat timber from the inside and leave the surface intact. A stud can look fine and be a hollow shell. That means any scope agreed before the walls are opened is a guess.

Expect it to change. A builder who says so up front is being honest, not vague.

Repair is not always replacement

Depending on the member, repairs can mean fixing a new piece alongside the old one, splicing in a new section or replacing the whole member. Which one suits depends on access and on how much sound timber remains. That choice belongs to the engineer or builder, not to the owner.

If you want the full picture of how the work is sequenced, read repairing termite damage: the right order.

Look at what is exposed while the wall is open

Open framing is a rare chance to see the moisture behind the shower, the state of the ventilation and any other damage. Termites and decay like the same conditions and often share a wall. If the timber is damp, find the reason before it is closed up again.

Keep the paperwork

Hold on to the inspection report, the treatment record, any engineer's assessment and the repair invoices. They matter at the next inspection and at the next sale. They will not usually lead to an insurance payout, since most home policies exclude termite damage.

Frequently asked questions

Can I replace damaged skirting myself?

Non-structural timber such as skirting is ordinary carpentry, but only once a licensed technician has dealt with the termites. Do not remove or disturb anything before that.

Do I need an engineer?

If a load-bearing member such as a bearer, joist, stud or lintel is damaged, yes. Judging the remaining sound section by eye is not reliable.

Why not repair first and treat later?

New timber would be exposed to a live colony, and repairs destroy the evidence a technician needs to find where the activity is coming from.

Sources

What this page explains is based on these official sources. If you check one and it does not match what you read here, send it to us and the article gets corrected.

Keep reading