Home › Barriers › Termite collars: what they protect and what they miss

Termite collars: what they protect and what they miss

A collar closes one of the easiest hidden routes into a house. It does nothing about the rest.

A termite collar seals the gap around a pipe

A termite collar is a physical barrier fitted around a pipe or conduit where it passes through a slab or footing. It blocks the gap that termites would otherwise use to climb up unseen. Collars are usually a stainless steel mesh or a sleeve of graded stone particles, and they are part of a wider termite management system.

Plumbing penetrations are one of the classic concealed entry points. A slab looks solid, but each pipe leaves a small gap.

Why penetrations matter

Termites do not need a big opening. A hairline crack is enough to reach the timber above. A pipe gap sits right where the slab meets the frame, so the route is short and hidden.

That is why a system built to AS 3660 treats penetrations as a priority. The aim is not to make entry impossible. It is to force termites into the open, where a mud tube can be seen on inspection.

Collars need to be fitted at the right time

Most collars go in while the slab is being poured or just before. Fitting one afterwards is awkward, and often not possible without breaking out concrete.

If your house is already built, ask what was installed and whether there are records. A termite management system should come with documents that show it.

What a collar cannot do

A collar protects one point. It does not cover the slab edge, the expansion joints or a garden bed piled against the wall. Termites go around a collar if there is an easier way in.

It also does not remove termites that are already in the building. If you see mud tubes or hollow timber, leave them alone and book a licensed timber pest inspector. Breaking the workings can push the colony onto a hidden route, as this guide on spraying explains.

Keep the collar visible and inspected

A collar only helps if someone can see it. Do not cover pipe areas with soil, paving or render. An inspector needs to check the zone for mud tubes, and a buried collar is a blind spot.

  • Do you have records of what was fitted and where?
  • Can the inspector see every pipe penetration?
  • Has anything been built up against the slab since?
  • When was the last inspection?

A collar without a yearly check is a hope, not protection.

Frequently asked questions

What is a termite collar?

It is a physical barrier fitted around a pipe where it passes through a slab. It is usually stainless steel mesh or graded stone, and it blocks a hidden gap termites could use.

Can I fit a termite collar myself?

Collars are normally installed during construction as part of a termite management system. Retrofitting is difficult, so ask a licensed professional what is possible for your house.

Does a collar stop termites completely?

No. It protects one entry point and forces activity into view. Regular inspections are still needed.

Sources

What this page explains is based on these official sources. If you check one and it does not match what you read here, send it to us and the article gets corrected.

Keep reading