Home › Risk factors › Termites in a brick house: yes, they can still get in

Termites in a brick house: yes, they can still get in

Bricks do not burn and do not rot, but a brick house is full of timber. Termites go where the timber is.

A brick house is not a termite-proof house

Many owners relax because the walls are brick. It is a common mistake. Termites do not eat brick, but they do not need to. They want the timber inside and underneath it.

Roof frames, floors, door and window frames, skirting boards and cupboards are all timber in most brick homes. Termites can reach them without ever leaving cover.

How termites get past the brick

Workers can build mud tubes over a brick face. They can also slip through very small gaps in mortar, cracks in a slab or the joints around pipes. Brick veneer houses add a cavity behind the bricks, which gives them a hidden route up the wall.

WhereWhat it can meanWhat to do
Cracks or gaps at the slab edgeHidden entry beside the footingInspector checks the slab edge and any barrier
Gaps around pipes and cablesEntry through a service penetrationHave it checked, do not seal it yourself
Mud tubes over the brick facePossible termite activityDo not touch; photograph and call a licensed inspector
Garden bed piled against the wallSoil bridging the visible edgeAsk a builder about clearing it
Cavity behind veneerConcealed route to roof or wall framesInspector assesses the risk

None of these proves termites are in your walls. They are the places an inspector looks.

The damage is usually hidden

In a brick house you often see nothing from outside. Termites can hollow a frame or skirting board and leave only a thin skin of timber. A skirting board that sounds hollow is a reason to call someone, not a reason to dig at it.

Do bricks need a barrier?

Yes, a brick house needs the same kind of protection as any other. That means a physical or chemical barrier fitted by a licensed pest management technician, plus regular inspections. Chemical products must be registered with the APVMA and applied by a licensed technician. Our guide to termite barriers explains the main types.

If you see mud or damaged timber, stop

If you see mud tubes, hollow timber or live termites, do not break the tubes and do not spray. Spraying or disturbing the workings makes the colony shut that route and re-enter somewhere hidden, and it destroys the evidence a technician reads.

Photograph what you can from a safe spot and book a licensed timber pest inspection. Treatment is not a do-it-yourself job.

If you are buying a brick house, do not skip the pre-purchase inspection because the walls look solid. Ask your conveyancer about anything that affects the contract, and your insurer what your policy covers.

How to walk around a brick house and note what an inspector should check

You cannot see inside the walls, but you can walk the outside in a few minutes. Do not touch or seal anything you find. You are making a list, not a diagnosis.

  1. Start at the slab edge. Look for cracks or gaps beside the footing, and check the edge is visible. A hidden edge means nobody can read it.
  2. Check the base of each wall. Garden beds or soil piled against the brick bridge the visible edge. Note them and ask a builder about clearing them.
  3. Follow pipes and cables where they enter. A gap around a service penetration is a possible entry. Have it checked rather than sealing it yourself.
  4. Scan the brick face for mud tubes. Termites can build over brick. If you see one, do not break it. Photograph it and call a licensed inspector.
  5. Tap skirting boards gently. A board that sounds hollow is a reason to call someone, not a reason to dig at it.
  6. Write it all down. Bring your notes to the next timber pest inspection.

The termite prevention page explains which fixes are yours and which belong to a licensed technician.

Brick, brick veneer or timber: where the hidden routes are

Brick does not make a house safe, but the way the walls are built changes where an inspector looks. This table shows the pattern. It does not rank which house is safest.

ConstructionTimber insideLikely hidden routeWhat an inspector pays attention to
Solid brickRoof frame, floors, door and window frames, skirting boardsMortar gaps, cracks and slab edgesSlab edge, service penetrations, mud tubes on the face
Brick veneerWall frames behind the bricks, plus everything aboveThe cavity behind the bricks, a route up the wallThe cavity, the base of the wall and any barrier
Timber frameMost of the structureDirect contact between soil and timberGround clearance, steps and the subfloor
Any type with a damp subfloorMore timber sitting in moistureMoist soil beside the footingDrainage, vents and moisture near the ground

The lesson is the same in every row. A barrier fitted by a licensed pest management technician and regular inspections matter more than what the walls are made of. See also termites in concrete slabs.

Frequently asked questions

Can termites eat through brick?

No, they do not eat brick. They travel over it in mud tubes or through small gaps and cracks to reach timber.

Are brick houses safer than timber houses?

They have less exposed timber, but they still contain frames, floors and roof timber. A brick house needs inspections like any other.

Does a brick veneer house have extra risk?

The cavity behind the bricks can hide a route up the wall, so inspectors pay attention to it.

Should I spray if I see mud tubes on bricks?

No. Spraying or breaking the tubes makes the colony reroute and destroys evidence. Photograph them and call a licensed inspector.

Sources

What this page explains is based on these official sources. If you check one and it does not match what you read here, send it to us and the article gets corrected.

Keep reading