Home › Risk factors › Subfloor clearance and termites: why inspectors need room

Subfloor clearance and termites: why inspectors need room

A cramped subfloor is hard to inspect and hard to dry out. Both problems favour termites.

Low clearance hides the problem until it is big

Termites work out of sight. In a subfloor with barely enough room to crawl, an inspector may not be able to see the timber at all. If nobody can see it, nobody can spot the early signs.

That is the real risk of poor clearance. It does not attract termites by itself. It lets them work for longer before anyone notices.

What clearance has to do with damp

A tight subfloor also moves less air. Soil stays damp, timber stays damp and the space smells musty. Those are the conditions termites and fungal rot both like.

Soil that has built up against the house over the years makes it worse. Garden beds, paths and landscaping can quietly cut the gap between the ground and the bearers. Check that it has not shrunk since the house was built.

Signs the subfloor is too cramped

What you noticeWhat it can meanWhat to do
The access hatch is blocked or stuckNobody has been under the house for a long timeClear the hatch and tell your inspector
Soil, pavers or garden beds sit close to the floor framingGround levels have crept upAsk a builder about regrading
Inspector reports limited accessParts of the subfloor could not be seenAsk what was missed and whether a re-inspection is possible
Musty smell at the ventsDamp air is sitting under the floorCheck the vents and the drainage
Mud tubes on piers, stumps or wallsPossible termite activityDo not touch them; photograph and call a licensed inspector

None of these proves termites are present. They show a subfloor that is harder to check than it should be.

Fixing clearance is a builder's job

Lowering the ground, cutting a larger access opening or reworking the framing changes how the house is built. It is not a weekend job. Get a builder to look at it, and ask your inspector first whether the work could disturb a treated soil barrier.

If the space truly cannot be made accessible, say so to your inspector. A report that lists the areas it could not see is more useful than one that quietly skips them.

Keep the vents and drainage working too

Clearance, ventilation and drainage work together. Make sure your subfloor vents are clear, and read our guide to subfloor drainage if water collects under the house.

If you see mud or damaged timber, stop

If you see mud tubes, hollow-sounding timber or termites themselves, do not break the tubes and do not spray. Spraying or disturbing the workings makes the colony shut that route and re-enter somewhere hidden, and it destroys the evidence a technician reads.

Photograph what you can from a safe spot and book a licensed timber pest inspection. Treatment is work for a licensed pest management technician using products registered with the APVMA, never a do-it-yourself job.

If you are buying, ask your pre-purchase inspector how much of the subfloor they could see. Ask your conveyancer about anything that affects the contract.

Frequently asked questions

How much subfloor clearance do I need?

It depends on the house, the state and when it was built, so there is no single figure to quote. Your inspector will tell you whether they can see the timber safely.

Does low clearance cause termites?

Not directly. It makes the subfloor harder to inspect and harder to dry, which favours termites and lets damage go unnoticed.

Can I fix a low subfloor myself?

No. Changing ground levels or framing is builder's work, and it can disturb a treated soil barrier. Talk to your inspector first.

What if the inspector could not get under the house?

Ask for the limits in writing and whether a re-inspection is possible once access is fixed. Do not assume the unseen areas are clear.

Sources

What this page explains is based on these official sources. If you check one and it does not match what you read here, send it to us and the article gets corrected.

Keep reading